亚信电子提醒您  
亲爱的客户您好:

假如在使用亚信USB 转以太网路产品有不正常的现象,请下载 " How to identify authentic ASIX USB to LAN Products " 文件,先自行确认一下是否正在使用非真正亚信USB转以太网路芯片的产品。如果您买到非真正亚信USB转以太网路芯片的产品,请找该产品制造商或经销商要求相关驱动程序与技术支持。

  我了解   
 
content
 
AXM22001-2A-C - IEEE 802.11b/g WiFi模块板 | 亞信電子
Asix
  
>>English
>>繁體中文
最佳浏览效果: 建议使用 IE 8.0以上Mozilla FirefoxGoogle Chrome 以上,屏幕分辨率设为1024x768
 
您是访客
| 登录 |
 
嵌入式以太网控制器
 Non-PCI 千兆以太网
 Non-PCI 百兆以太网
 MII/RMII 百兆以太网
超高速USB以太网控制器
 USB 3.0 千兆以太网
 USB 2.0 千兆以太网
 USB 2.0 百兆以太网
嵌入式网络/USB单芯片
 嵌入式Wi-Fi单芯片
 嵌入式以太网单芯片
 USB KVM切换器单芯片
I/O 连接控制器
 PCIe 桥接器
 PCI 桥接器
 USB 桥接器
 RS-232/RS-485收发器
      5V RS232 收发器
      3V RS232 收发器
      5V RS485 收发器
      3V RS485 收发器
 EL驱动器
嵌入式无线模块
 嵌入式Wi-Fi模块
 嵌入式蓝牙模块
首页 >> 产品信息 >> 嵌入式无线模块 >> 嵌入式Wi-Fi模块 >> AXM22001-2A-C

 AXM22001-2A-C -- IEEE 802.11b/g WiFi 模块板

The AXM22001-2A-C is a 2.4GHz 802.11b/g WiFi module board which integrates AX22001 and Airoha AL2230S RF transceiver on board to provide a complete WiFi module solution with various user or host interfaces supported. The AXM22001-2A-C is a surface mountable module with castellated mounting holes which offers smaller-form-factor, lower-cost, pre-calibrated RF front-end and pre-certified WiFi module board to free the user from RF and antenna design tasks and regulatory compliance testing, ultimately providing quicker time to market. The user can design his host board with desired function and interface circuits and assemble it with the AXM22001-2A-C WiFi module board through the castellated mounting holes.

规格:

    • Integrated 2.4GHz, IEEE 802.11b/g compatible WiFi connectivity
    • Integrated PCB antenna
    • Max outdoor range up to 300m (984 ft.), line of sight
    • Supports operation in Simple AP(SAP) or Station (In Infrastructure or Ad-Hoc) mode
    • Supports 802.11i security:
    • WEP-64/128, TKIP (WPA-PSK) and AES (WPA2-PSK) in Station mode
    • WEP-64/128 in SAP mode
    • Dual 8-bit 1T 8051/80390 CPU @ 80MHz
    • 1MB shared Flash memory for MCPU and WCPU program code and configuration data storage
    • 64KB data memory for MCPU
    • 4 UART interfaces
    • High Speed SPI interface (master or slave mode)
    • I²S or PCM interface
    • Local Bus host interface (master or slave mode)
    • MII or RMII interface
    • I²C interface
    • Up to 32 GPIOs (4 GPIO ports of 8 bits each)
    • Supports real-time clock, with option to use independent power supply from lithium battery
    • Supports TCP, UDP, ICMP, IGMP, IPv4, DHCP, BOOTP, ARP, DNS, SMTP, SNTP, UPnP, PPPoE and HTTP in software
    • Supports network boot over Ethernet or WiFi using BOOTP and TFTP
    • Single operating voltage: 3.3V typical
    • Board size: 51.0mm x 28.0mm x 4.5mm surface mountable module

 选型指南

Embedded_Wi-Fi_Module_Selection_Guide.jpg

 开发板

AX22001 802.11b/g Generic Development Board  可提供
 This is a generic development board with AX22001 802.11b/g WiFi module board for RS-232 to WiFi reference design or SPI to WiFi reference design. (with AXM22001-2A-B WiFi Module board)
AX22001 802.11b/g WiFi Speaker Reference Design Board   可提供
 This is a WiFi speaker reference design board with AX22001 802.11b/g WiFi module board. (with AXM22001-2A-B WiFi Module board)

技术文档

 产品简述 , 产品介绍和数据手册

AXM22001-2A-C 802.11b/g WiFi Module Board Datasheet   
Contact Us

硬件设计文档

 参考电路图

AXM22001-2A-C WiFi Module Board Reference Schematic   
Contact Us

 物料清单, 应用说明和布线指南

AXM22001-2A-C WiFi Module Board BOM File  
Contact Us

 PCB 版图, Gerber 和 IBIS模型文件

AXM22001-2A-C WiFi Module Board Gerber Files   
Contact Us
AXM22001-2A-C WiFi Module Board PCB Layout File (PowerPCB)   
Contact Us

[使用条款]    [网站地图]
Copyright © 2013-2017 ASIX Electronics Corporation All Rights Reserved.