亞信電子提醒您  
親愛的客戶您好:

假如在使用亞信USB轉乙太網路產品有不正常現象,請下載 " How to identify authentic ASIX USB to LAN Products " 文件,先自行確認一下是否正在使用非真正亞信USB轉乙太網路晶片的產品. 如果您買到非真正亞信USB轉乙太網路晶片的產品,請找該產品製造商或經銷商要求相關驅動程式與技術支持.

  我瞭解   
 
content
 
AXM22001-2A-C - IEEE 802.11b/g WiFi模組板 | 亞信電子
Asix
  
>>English
>>简体中文
最佳瀏覽效果: 建議使用 IE 8.0以上Mozilla FirefoxGoogle Chrome ,螢幕解析度設為1024x768
 
您是訪客
| 登錄 |
 
嵌入式乙太網路控制器
 Non-PCI 超高速乙太網路
 Non-PCI 高速乙太網路
 MII/RMII 高速乙太網路
超高速USB乙太網路控制器
 USB 3.0 超高速乙太網路
 USB 2.0 超高速乙太網路
 USB 2.0 高速乙太網路
嵌入式網路/USB單晶片
 嵌入式Wi-Fi單晶片
 嵌入式乙太網路單晶片
 USB KVM切換器單晶片
I/O 連接控制器
 PCIe 橋接器
 PCI 橋接器
 USB 橋接器
 RS-232/RS-485收發器
      5V RS232 收發器
      3V RS232 收發器
      5V RS485 收發器
      3V RS485 收發器
 EL驅動器
嵌入式無線模組
 嵌入式Wi-Fi模組
 嵌入式藍牙模組
首頁 >> 產品訊息 >> 嵌入式無線模組 >> 嵌入式Wi-Fi模組 >> AXM22001-2A-C

 AXM22001-2A-C -- IEEE 802.11b/g WiFi 模組板

The AXM22001-2A-C is a 2.4GHz 802.11b/g WiFi module board which integrates AX22001 and Airoha AL2230S RF transceiver on board to provide a complete WiFi module solution with various user or host interfaces supported. The AXM22001-2A-C is a surface mountable module with castellated mounting holes which offers smaller-form-factor, lower-cost, pre-calibrated RF front-end and pre-certified WiFi module board to free the user from RF and antenna design tasks and regulatory compliance testing, ultimately providing quicker time to market. The user can design his host board with desired function and interface circuits and assemble it with the AXM22001-2A-C WiFi module board through the castellated mounting holes.

規格:

    • Integrated 2.4GHz, IEEE 802.11b/g compatible WiFi connectivity
    • Integrated PCB antenna
    • Max outdoor range up to 300m (984 ft.), line of sight
    • Supports operation in Simple AP(SAP) or Station (In Infrastructure or Ad-Hoc) mode
    • Supports 802.11i security:
    • WEP-64/128, TKIP (WPA-PSK) and AES (WPA2-PSK) in Station mode
    • WEP-64/128 in SAP mode
    • Dual 8-bit 1T 8051/80390 CPU @ 80MHz
    • 1MB shared Flash memory for MCPU and WCPU program code and configuration data storage
    • 64KB data memory for MCPU
    • 4 UART interfaces
    • High Speed SPI interface (master or slave mode)
    • I²S or PCM interface
    • Local Bus host interface (master or slave mode)
    • MII or RMII interface
    • I²C interface
    • Up to 32 GPIOs (4 GPIO ports of 8 bits each)
    • Supports real-time clock, with option to use independent power supply from lithium battery
    • Supports TCP, UDP, ICMP, IGMP, IPv4, DHCP, BOOTP, ARP, DNS, SMTP, SNTP, UPnP, PPPoE and HTTP in software
    • Supports network boot over Ethernet or WiFi using BOOTP and TFTP
    • Single operating voltage: 3.3V typical
    • Board size: 51.0mm x 28.0mm x 4.5mm surface mountable module

 選型指南

Embedded_Wi-Fi_Module_Selection_Guide.jpg

 開發板

AX22001 802.11b/g Generic Development Board  可購買
 This is a generic development board with AX22001 802.11b/g WiFi module board for RS-232 to WiFi reference design or SPI to WiFi reference design. (with AXM22001-2A-B WiFi Module board)
AX22001 802.11b/g WiFi Speaker Reference Design Board   可購買
 This is a WiFi speaker reference design board with AX22001 802.11b/g WiFi module board. (with AXM22001-2A-B WiFi Module board)

技術文件

 產品簡介,產品介紹和數據表

AXM22001-2A-C 802.11b/g WiFi Module Board Datasheet   
Contact Us

硬體設計文件

 參考線路圖

AXM22001-2A-C WiFi Module Board Reference Schematic   v0C22011-07-12
Contact Us

 材料清單,應用產品設計注意事項和佈局使用指南

AXM22001-2A-C WiFi Module Board BOM File  
Contact Us

 PCB佈局,Gerber 和IBIS模型檔案

AXM22001-2A-C WiFi Module Board Gerber Files   
Contact Us
AXM22001-2A-C WiFi Module Board PCB Layout File (PowerPCB)   
Contact Us

[使用條款]    [網站地圖]
Copyright © 2013-2017 ASIX Electronics Corporation All Rights Reserved.